Vidikron Vision 65 Specifications download pdf (Page 38)

Installation

26 Vidikron Vision 150 Owner’s Operating Manual

PRE

IMINAR

3.4

Installing the Projection

Lens

The projection lens is shipped separately from the projector. Proceed as follows to install the

projection lens:

1. Remove the lens plug from the lens opening in the projector.

2. Place the lens cap on the projection lens to protect it from being damaged during the

installation process.

3. Remove the rear cap from the lens. This protective cap is only used during shipping to

protect the lens from damage.

4. Slide the new lens into the lens opening of the projector. Make sure to align the

connector on the side of the lens with the connector assembly on the lens retaining ring;

see Figure 3-7.

As you connect the lens, you may have to re-align it slightly until the tabs on the lens fit

into the slots in the lens retaining ring.

Figure 3-7. Lens Assembly (Front View)

5. With the lens fully inserted (and connected), turn it clockwise until the lens release

button “pops” indicating the lens is fully inserted.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 113 114

No comments

Vidikron Vision 65 Specifications Page 38