Vidikron Vision 65 Specifications download pdf (Page 41)

Installation

Vidikron Vision 150 Owner’s Operating Manual 29

PRE

IMINAR

3.6

Mounting the Vision 150

There are several methods for mounting the projector. Depending on your chosen

installation, one method may be more suitable than another.

Floor Mounting (Upright)In typical front and rear screen installations, the projector can be mounted to a secure and

level surface such as a table or cart. Carts are useful when moving a projector during a

presentation or from site to site. If possible, lock the wheels when it’s in position to prevent it

from being moved during a presentation.

Ceiling Mounting (Inverted)For fixed installations, and for those that want the projector out of sight or have a limited

space for projector and audience, you can invert the Vision 150 and suspend it from the

ceiling using a specially-designed ceiling mount fixture.

The projector can also be inverted and placed in an enclosure above and behind the viewing

area. Install four feet on the inside bottom surface of the enclosure on which the projector

can rest. A variety of materials can be used for this purpose (for example, rubber crutch tips

or turntable feet).

Adjusting the Projection

Angle

If the Vision 150 is ceiling-mounted and the screen is significantly lower than the projector,

you can tilt the projector at an angle by adjusting the ceiling mount.

The projector can be rotated (front-to-back) up to 360 degrees and mounted without it

affecting performance. However, to ensure optimal performance of the lamp, limit the

side-to-side tilt of the projector to ±15 degrees; see

Figure 3-8.

Figure 3-8. Mounting Angle Ranges (Front-to-Back and Side-to-Side)

For a floor (non-AutoScope) installation, turn the two adjustable feet on the bottom of the

projector to adjust the projection angle.

If you do either of these things, you may need to make keystone adjustments or vertically

shift the image using the on-screen display (OSD) controls, to compensate. For detailed

instructions, refer to

Using the On-Screen Menus on page 63.

Use only the Vidikron-approved ceiling mount kit (Vidikron part number

VIHK-000355 or equivalent) designed for your projector. Install the

mount kit according to the instructions provided with it.

Note

± 360º

± 15º

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 113 114

No comments

Vidikron Vision 65 Specifications Page 41