Vidikron Vision 65 Specifications download pdf (Page 95)

Maintenance and Troubleshooting

Vidikron Vision Model 150 Owner’s Operating Manual 83

PRE

IMINAR

13. Press ENTER to accept the change. This adds the new lamp serial number to the Lamp

History menu and resets the Lamp Hours timer to “0.” Lamp Mode and Lamp Limit

remain as they were for the previous lamp and can be changed at any time.

Figure 5-5. Recording the Serial Number of a New Lamp

Filter ReplacementWhenever you replace the lamp – or more often if the projector is installed in an extremely

dusty environment – you should also replace the two filters located at the front and right

side of the projector.

1. Loosen the six screws holding right side filter access

panel in place. Then, remove the panel.

2. Loosen the screw holding front filter access panel in

place. Then, remove the panel.

3. Pull the filters out of the projector and discard. Do not

reuse filters.

4. Insert the new filters with the wired side in.

5. Replace the filter access panels and tighten the

screws to secure them.

Always record the serial number of a new lamp. Do this only if you have

just installed a new lamp. This will ensure that the lamp timer is not reset

on an old lamp and that the number of hours logged on the lamp is

accurate.

Lamp Hours 147

Lamp S/N 123456789

1. Lamp Message

2. Lamp Limit 1000

3. Lamp Mode Power

4. Power 500

5. Intensity 0

6. RVR 3

7. Lamp History

8. Change Lamp

9. Reserved

Lamp Adjust

Note

Front Filter

Access Cover

Right Side Filter

Access Cover

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 113 114

No comments

Vidikron Vision 65 Specifications Page 95