Vidikron Vision 30 User Manual download pdf (Page 39)

Vidikron Vision Model 30 Owner’s Operating Manual

On-Screen Display Menus

Projector Status

Vision Model 30

Picture Adjust

Image Option

Projector Status

Installation

Service

ISF Calibration



Default



Sleep Timer



Lamp Hours

Projector Status

Default Load

Sleep Timer 30 Minutes

Lamp Power 200 W

Lamp Hours +8 Hours

0 Minutes

To load default settings, configure the sleep timer or adjust the lamp, press MENU, then

press the ▲ or ▼ arrows to highlight Projector Status and press ENTER. The Projector

Status sub-menu will then appear (see above). Press EXIT to return to the previous menu

or press MENU to close all menus.

To restore the default image settings for the current input source ONLY, press the ▲ or ▼

arrow buttons to highlight “Load,” then press ENTER.

The Sleep Timer automatically puts the projector into standby mode after the amount of

time you specify here. (A warning appears on-screen one minute before this is to occur.)

Press the ◄ or ► arrows to set the timer for anywhere from 10 minutes to 3 hours, in 10-

minute increments. To disable the Sleep Timer, set it to 0.

Select Lamp Power from the Set Up Menu to adjust the lamp output level. You can choose

to run the lamp as bright as possible (250W; this is the default setting) or you can choose

the lower (200W) setting. Generally, lower lamp output can prolong the life of the lamp,

but decreases brightness.

Lamp Hours indicates how long the currently-installed lamp has been in service. (This

part of the menu is read-only.)



Lamp Power

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 57 58

No comments

Vidikron Vision 30 User Manual Page 39