Vidikron Vision 30 User Manual download pdf (Page 51)

Vidikron Vision Model 30 Owner’s Operating Manual

RS-232 Setup

Connecting RS-232 to

the Projector

1. Connect a D-Sub 9-pin female-to-RJ-11 adapter (not included) to a COM port on

your PC. The adapter must be wired as follows:

RS-232 Pin Assignments

D-Sub 9-pin female 4-pin RJ-11 Function

2 2 Transmit Data

3 3 Receive Data

5 1, 4 Ground

1, 4, 6, 7, 8, 9 -- Not Connected

2. Connect the COM port to the RS-232 port on the projector. Use a standard, 4-wire

RJ-11 telephone cable, wired straight-through.

3. Start a terminal session on your PC using a terminal-emulation program, such as

HyperTerminal.

4. Configure the COM port on the PC as follows: no parity, 8 data bits, 1 stop bit and

no flow control. Set the baud rate to match that of the projector (115200, 38400 or

9600).

5. Press ENTER. You should see a command prompt (>) in the terminal window.

6. Type the desired command from the table that follows and press ENTER. For example,

to set the aspect ratio to Letterbox, type x063x <Enter>.

D-Sub 9-pin female

RJ-11 to D-Sub 9-pin (not included

)

Yellow

Yell

Red

Black

Green

Gree

Blac

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 57 58

No comments

Vidikron Vision 30 User Manual Page 51